Everything But The Weed

Approved by:
Linda Maze, a Wedding photography Gainesville FL in Gainesville Florida

So as to acquire honey from your beehive you have got to have the ability to extract the honey from the honey comb. So as to do this you have to utilize a honey extractor. There are manufactured honey extractors offered in the marketplace, they normally cost something like $200 to three hundred dollars, the standard cost of starting a new hive of honey bees. If there is a group of beekeepers in an area they will at times combine their cash collectively to buy a honey extractor that they share. If you are not in a large beekeeping surroundings and don’t like to spend a couple of hundred dollars on a manufactured one, you might want to construct your very own honey extractor.

The materials you’ll need to construct your honey extractor consist of; a metal rod that’s not less than 1 meter long and is thickly threaded, 2 bicycle wheel rims, 2 pieces of wood, a meter of 2-3mm fencing wire, a big metallic drum, 10 bolts for the steel rod, 4 400mm sections of 8mm threaded rod, a self centering bearing, 6 coach screws, and a pillow block bearing. When selecting a large metallic drum for your very own selfmade honey extractor ensure that is was not used to stock potentially toxic materials. The utensils you will require for building your very own honey extractor comprise; an electric drill, a welding machine (and ideally some welding experience), a socket set, and a hack saw.

The very first thing your going to do is remove the side of the drum that doesn’t have two pouring holes, the newly opened side would be the top of your honey extractor. Utilize the coach screws to attach one of many pieces of wood across the underside of the drum. As soon as the wood is in place make use of coach screws to fasten the pillow block. After putting in the threaded rod through the center of the first bicycle rim, securely bolt the rim to the rod roughly ten centimeters from the end of the rod. On the reverse side of the rod you’ll want to thread a however for the other wheel, the next wheel will rest on this nut. When both of the wheel rims are in place you’ll want to drill holes in 4 spots around each wheel, when this job is finish you use the 8mm rods to fasten the wheel rims together. Use two nuts onto the rod. Make sure that two cm of rod stick out.

Once that is complete you’ll cut a slit that is10mm deep and 3mm wide into the end of the rod. After this thread the lock the nuts together on the end of the rod. As soon as you assume the nuts are in place make use of the welding machine to permanently lock them into place. Fasten the wire to the the spokes of the bottom wheel rim, roughly 5-8cm from the rim. You have now successfully made the basket of your honey extractor.

Take your newly crafted extractor basket and put it into the drum, settling it on the pillow bearing. Now you are going to want to bolt a second piece of wood to the edges of the drum and the self centering bearing.

Put a screwdriver bit in your drill, ans use it to turn the threaded rod.