Everything But The Weed

Approved by:
Linda Maze, a Wedding photography Gainesville FL in Gainesville Florida

Wind power is the result of changing the wind into a far more helpful form, eg electricity.  A wind turbine is mostly used for this.  Wind power is superb for areas that have average wind speeds of greater than 10 miles per hour.  You get free electricity.  

Materials you’ll need:

– Treadmill motor

– Plastic 2-liter pop bottles

– A steel bicycle frame

– Zip ties

Instructions to build a wind generator:

1.  Find a motor from a treadmill.  You can frequently find one in a skip at apartments near colleges.  Other sources of this motor can be free cycle and Craigslist.  Spinning this motor using an outside source can create electricity.  

2.  Fuse the motor onto the axle of a bicycle pedal (the pedal should be removed) .This involves scaffolding to be built for alignment.  Mount the motor housing by fusing a pipe to bridge the area beginning at the frame on the way to the motor housing, making sure the motor is stubbornly in position.  The housing shouldn’t spin while the axle of the motor does.  

3.  Construct the blades by zip-tying plastic from the pop bottles at an angle between the spokes for the wind to make the wheel whisk.  The pop bottle plastic is detached by winding a 2-inch strip from the bottle in a curving trail that permits a long strip to be sliced.  The zip ties should be linked thru holes in the plastic that can be done by using a hole punch.  If there’s still an opening that must be filled on the spoke because the plastic is much too short, continue filling it with another piece of plastic that is zip tied in place.  There must be an area of the wheel that is enclosed with these blades that is 33% of the entire face of the wheel that the wind will shove.  

4.  Ensure the blades do not touch anything as they turn.  Also insure that this device is out of reach, especially by children as the blades could harm them.  Save on space by cutting down the remainder of the bike.  Mount the generator up high.  The generator will make noise, which could scare away animals, but may also provoke your neighbors (only you can decide if that’s bad).  

5.  Place the generator on the highest place attainable.  Place the wires beginning at the generator towards the preferred site for power.  Don’t charge batteries on this because they won’t get charged and run the motor instead.  Ask an electrician if you need to recharge batteries with the generator.  

By following these instructions to build a wind generator, you may find that creating your own residential wind generator is fun and straightforward.

Visit the authors other article HOMEMADE WINDMILL in this internet site Do It Yourself Solar Panels